How To Insert Batteries; User Notices; Care And Maintenance - GE Consumer & Industrial GE AIR 107 Owner's Manual And Installation Instructions

How to insert batteries

How to insert batteries into the
remote control unit
• Slide the battery cover off from the back
of the remote control unit.
• Insert two AAA batteries and press the
'ACL' button.
• Slide the cover back in place.
NOTE:
• Do not mix new and used batteries or
rechargeable and non-rechargeable
batteries.
• Remove batteries from the remote
control unit when it is out of service for
long periods.
• Fresh batteries can normally be expected
to last up to one year.
• Operate the remote control unit at least
1 meter or more away from a television
or audio device.
10

User notices

• Do not aim the air current directly at
animals or plants.
• Disconnect the power if the unit is out of
service for extended periods.
• Clean the air filter and maintain the air
cleaner on a regular basis.
• Remove batteries if the remote controller
is out of service for long periods.
• Avoid strong sunlight and draw curtains
or shades when cooling.
• Keep windows and doors shut to avoid
the loss of conditioned air.
• Select the most appropriate temperature
to save energy. Keep the room
approximately 5°C cooler than the
outside temperature when operating in
COOL mode.
• Adjust the direction of the airflow
appropriately. Remember that warm air
rises and cool air sinks, so adjust the
louver downward for heating and upward
for cooling to take advantage of natural
convection currents.

Care and maintenance

CAUTION
• Always turn power off and remove the
power plug before cleaning the unit.
• NEVER sprinkle water on either the
indoor or the outdoor unit to clean it.
• Wipe the indoor and outdoor units with
a clean, soft dry cloth or a cloth slightly
moistened with water or cleaner.
• Before starting the unit, be sure that
nothing obstructs the air outlet and the
intake vents.
Cleaning the outdoor unit
1. Regularly clean dust from outdoor unit.
2. Repaint any rust colored areas on the
outdoor unit.
Cleaning the indoor surface panel
1. Pull in the direction indicated by the
arrows to remove surface panel.
2. Wipe with a cloth slightly moistened with
water or cleaner and then dry in the
shade. Do not use water above 45°C to
wash the panel. It could cause
deformation or discoloration.
3. Reinstall the surface panel.
11