MaxTech Plug & Play Internal Voice/FAX/Data/SVD Modem User Manual page 13

%C1 Enable MNP Class 5 data compression
&Q_ &Q0
&Q5 V.42 data link with fallback options
&Q6
\A_ \A0
\A1
\A2
\A3
\Bn Send a 1/10 second line break to the modem,
where n = 1 to 9. At normal connect, the default
is 3
\J_ \J0
\J1
\Kn Set break control, where n= 0 to 5. The effect of
this command depends on the modem's
operating condition. Default is 5.
\N_ \N0
\N1
\N2
\N3
\N4
\N5
\N7
\Q_ \Q0
\Q1
\Q3
\T n
\V_ \V0
\V1
\V2
\X_ \X0
\X1
compression
only
Direct data link only (same as \N1)
Normal data link only (same as \N0)
64-character maximum MNP block size
128-character maximum MNP block
size
192-character maximum MNP block size
256-character maximum MNP block size
DTE speed is independent of modem
connect speed
DTE speed matches the modem connect
speed
Normal data-link only
Direct data-link only
MNP data link only
V.42/MNP/Normal data link
V.42 data link only
V.42/MNP/Normal data link
V.42/MNP/Normal data link
Disable flow control
XON\XOFF flow control
RTS\CTS flow control
Inactivity timer (n=0-255 minutes)
Disable error correction protocol result
code
Enable error correction protocol result
code
Enable error correction protocol result
code
If XON/XOFF flow control is enabled,
do not pass XON/XOFF to remote
modem or local DTE
If XON/XOFF flow control is enabled,
11