Installation - Viking FDBB5361 Installation Manual

General Information
• Most of the unit's weight is at the top. Extra
care is needed when moving the unit to
prevent tipping.
• DO NOT remove protective film until unit is in
operating position.
• All four leveling legs must make contact with
the floor to support and stabilize the full weight.
• DO NOT drop unit.
• Remove exterior shipping materials prior to
moving unit into home.
• Use two or more people to move and install
unit. Failure to follow this instruction can result
in back or other injury.
• To avoid personal injury, wear gloves when
performing any installation procedure and wear
eye protection when cutting metal straps.
Moving Unit
1
Remove shipping brackets from skid by
removing four bolts (two on each side) with a
1/2" deep-well socket wench and a pair of pliers.
Note: Tilting unit is not required to remove
shipping brackets.
60
Tip Over Hazard
Appliance is top heavy and tips easily when not
completely installed. Keep doors closed until
appliance is completely installed and secured per
installation instructions. Use two or more people
to move and install the appliance. Failure to do
so can result in death or serious injury.
Unpacking unit
1. Remove top and bottom strap.
2. Remove top cap.
3. Cut rear of carton approximately 1/4" (0.6 cm)
to 1" (2.5 cm) from right corner with a utility
knife extended 1/4" (0.6 cm).
4. Remove carton and exterior packaging.
Save cardboard shipping material to protect
floor surface when installing unit. Remove
anti-tip board, kickplate and door trim pieces
(DF models) from rear of unit.
2
Slip cart between unit and skid. Remove unit from skid.
Note: Use excess packaging to protect decorative trim;
also, verify that leveling legs are up (0" adjustment).

Installation

1
Place unit in front of cutout.
3
Using an 8" magnetic nut driver,
remove the two 1/4" screws.
61
2
Pull the center grille louver up
at an angle and pull out.
4
Remove grille assembly.