Before First Use - George Foreman Wheel-It and Grill-It GP100SILCAN Owner's Manual

1. Remove the Grill and any packaging materials.
2. Place the Base Frame on a flat, level surface.
3. Slide the Transport Lock to the right and raise the Transport Handle from
the storage position.
4. Remove the Grill Plate, Grill Base, Lid and Drip Tray. Wipe the Grill Base and
Lid with a damp cloth to remove any dust. Wash the Grill Plate and Drip
Tray in warm, soapy water. Rinse and dry thoroughly.
5. The Handle/Vent and mounting
hardware, (Screw/Washer) are
shipped in an inverted fashion,
requiring minor assembly.
Remove the Handle/Vent from
the inside of the Lid by unscrew-
ing the Screw/Washer. Remove
all parts, then properly position
the Handle/Vent on the top of the
Lid. Make sure the Handle/Vent
stop pin enters the Vent slot in
the Lid. From the inside of the
Lid, place the Screw/Washer
through the hole in the Lid and
Handle/Vent. Securely fasten
with a Phillips head screw driver.
See Figure 1.
6. Slide the Drip Tray into the slots
in the Grill Base.
7. See "Grilling Positions" on the
following pages and place the
Grill Base on the Base Frame.
Refer to Figure 2 and hook the
Slotted Bracket around the
Locator Peg under the Base
Frame. Align the hole in the Grill
Base with the Locator Peg on
the opposite side of the Base
Frame.
8. Place the Grill Plate on the Grill
Base and place the Lid over the
Grill Plate.
NOTE: If the Lid is to be removed
temporarily it may be placed
between the Grill and the Wheels as
shown in Figure 3.

Before First Use

Drip Tray
7
Handle/Vent
Vent Slot
Screw/Washer
Figure 1
Slots for
Drip Tray
Hook the
Slotted
Bracket
Under Base
Frame
Locator Peg
Locator
Peg
Figure 2
Figure 3
Lid