Instructions For Cleaning - George Foreman Wheel-It and Grill-It GP100SILCAN Owner's Manual

CAUTION: Grill surfaces are hot during use. Allow Grill Plate, Drip Tray, Lid
and Grill Base to cool completely before handling and cleaning.
1. Turn the Temperature Control Knob to the LOCK/OFF position and allow the
Grill to cool before disassembling and cleaning.
2. Remove the propane cylinder.
3 Remove the Grill Plate and empty the Drip Tray.
4. Wash the Grill Plate and Drip Tray with warm, soapy water and a plastic
scouring pad. Rinse and dry thoroughly. Do not use steel wool, coarse
scouring pads or harsh or abrasive cleaners. If necessary, use a nylon bris-
tle brush to loosen hardened food particles.
5. Wash the inside of the Lid with a solution of mild detergent and water or use
a grill cleaner with nylon bristle brush. Rinse and allow to completely air dry.
Do not use a caustic grill cleaner.
6. Wash exterior parts with a soft sponge and warm clear water. Nonabrasive
cleaners may also be used.
7. Use a damp cloth to clean the inside
of the Grill Base.
Cleaning the Burner Assembly
IMPORTANT: Clean burner assembly prior
to use after storing, at the beginning of
grilling season or an inactive period of one
month. Spiders and insects like to build
nests in burner tubes, especially during
colder months. The nests can cause fires
in burner tubes or under grill.
In order to clean the inside of the burner
tubes, the Burner Assembly must be
removed from the Grill. Make sure the
propane cylinder, Lid, Grill Plate and Drip
Tray have been removed before proceed-
ing.
1. Turn the Grill Base upside down. Refer
to Figure 11 and locate the clip that
holds the venturi to the Regulator
Assembly. Pull straight up on the clip
and set it to the side.
2. Refer to Figure 12 and locate the two
machine screws that secure the
Burner Assembly to the Grill. Loosen
and remove these screws, making
sure you retain the screws, washers
and hex nuts for reassembly.

Instructions For Cleaning

Bottom View of
Regulator Assembly
Clip
(P/N 21643)
16
Figure 11
Venturi
Hex Nut
Machine Screw
and Washer
Figure 12