Caution - Conair LWD400RCSC Instruction Manual

3. Rinse the shaver cutter and foil frame
under running water or in a sink, with the
power switch turned off. (You can use the
cleaning brush which is included.) Do not use
hot water. Use only warm or cold water.
4. After wet cleaning, allow the foil frame and
cutters to air-dry before closing foil frame.
Replace shaver head back onto the shaver
until it clicks into place. Wipe the surface of
the main unit with a dry towel. Do not dry the
foil area. Let the shaving head air-dry. Once
the shaving head is dry, replace the plastic
protection cap.
5. The cutter can also be cleaned with the
cleaning brush provided.
6. If the body of the shaver becomes dirty,
wipe off with a damp cloth and mild detergent
or soap. Never use thinners, other solvents, or
any harsh cleaners.

CAUTION

1. When shaking off excess water, hold the
main unit firmly to prevent releasing the head
assembly or dropping the unit.
2. Do not use a dryer or heater to dry the
shaver. This may result in malfunction or
damage to the shaver.
NOTE: Never pull on the charging stand cord.
Never twist or wrap the cord around the charg-
ing stand. Lay it flat in the storage pouch pro-
vided with the cord coiled up when not in use.