Replacing The Dual Foils; Replacing The Dual Foils And Cutter - Conair LWD400RCSC Instruction Manual

REPLACING THE DUAL FOILS

1. Press the foil frame release buttons on
the side and lift the head off the top of the
shaver. (see figure 2)
Press Here
figure 2
2. To replace foils, gently remove the
existing foil and shaver head. Position
replacement head, being careful not to
push on the foils. Then press the carrier
down until it clicks into place. That's all
there is to it. Replace the foils when you
find you have to push harder on the shaver
to get a close shave, or if you have to go
over your leg area more often to get a
smooth result. It is also time to replace the
foils if you experience skin irritation.
Replacement time will depend on how
often you use your shaver and how quick-
ly your hair grows.
Caution: Never replace the cutters without
replacing the foils as well.
Press Here
1. Remove the foil frame. (see figure 3)
2. Hold both sides of the inner blades and
pull straight up. (see figure 4)
REPLACING THE
DUAL FOILS & CUTTER
Press Here
figure 3
Hold Here
spring
figure 4
Lift
Press Here
Hold Here