Before You Begin Cleaning; How To Use - Vax Power5 C85-P5-Be Let's Get Started

PLEASE READ 'LET'S TALK SAFETY' AT THE BEGINNING BEFORE USE

Before you begin cleaning

• Always switch off and unplug the vacuum cleaner before connecting or disconnecting the hose/attachments,
or removing and emptying the dirt container.
• The vacuum cleaner is equipped with a thermal cut-out. If for any reason the vacuum cleaner does overheat the
thermostat will automatically turn the vacuum cleaner off. If this happens, switch the vacuum cleaner off and unplug
from electrical socket. Remove and empty the dirt container also check the vacuum cleaner for blockages. Allow the
vacuum cleaner to cool for approximately 1 hour (if you have cleaned the filters please wait 24 hours for the filters
to fully dry before putting back into the vacuum machine).
• Tap the pre-motor filter over a bin every 4-6 uses to remove dirt/debris.
• If the vacuum cleaner is blocked, switch off and unplug before removing the blockage.
Assembling your cylinder
Click!
Press both buttons at the end of the
hose and push hose into the hose
entry point.

How to use

Fully unwind the power cord.
A yellow mark on the cord indicates
the recommended cord length.
Do not exceed the cord beyond the
yellow mark.
Insert the hose grip into the
telescopic extension tube. Press the
button on the telescopic extension
tube and adjust to required length.
Plug in and switch the unit on by
pressing the power button.
Getting started
Insert the other end of the telescopic
extension tube into the floor head.
When unwinding the
power cord always pull
out to the yellow marker
but no further.
CAUTION