Table of Contents
Advertisement
DISPlAYED MESSAGES
DISPlAYED MESSAGE
Fill TanK
ground Too Fine adJuST
Mill
alternating with...
inSerT WaTer SPouT and
PreSS oK
inSerT WaTer SPouT
eMPTy groundS ConTainer
inSerT groundS ConTainer
add Pre-ground CoFFee
deSCale
leSS CoFFee
Fill BeanS ConTainer
inSerT inFuSer aSSeMBly
CloSe door
inSerT MilK ConTainer
PreSS Clean
general alarM
POSSIBlE CAUSE
•
Insufficient water in the tank.
•
The grinding is too fine and the coffee is delivered
too slowly or not at all.
•
The water spout is not inserted or is inserted
incorrectly.
•
The grounds container is too full or more than 3
days have passed since you last made coffee (this
guarantees correct hygiene of the machine).
•
After cleaning, the grounds container has not been
replaced.
•
The " pre-ground coffee" function has been selected
without placing any pre-ground coffee in the funnel.
•
The machine must be descaled.
•
Too much coffee has been used.
•
The coffee beans have run out.
•
The pre-ground coffee funnel is clogged.
•
The infuser has not been replaced after cleaning.
•
The service door is open
•
The milk container is not inserted correctly.
•
Milk has been delivered recently and the tubes
inside the milk container must be cleaned.
•
The inside of the appliance is very dirty.
SOlUTION
•
Fill the tank with water and/or insert it correctly,
pushing it as far as it will go until it clicks into place.
•
Repeat coffee delivery and turn the grinding
adjustment knob one click clockwise towards "7"
while the coffee mill is in operation. if after making
at least 2 coffees delivery is still too slow, repeat
the correction procedure, turning the grinding
adjustment knob another click until delivery is correct.
if the problem persists, press the oK button to deliver
water from the spout until it flows out normally.
•
Insert water spout as far as it will go.
•
Empty the grounds container and clean, then
replace. important: when removing the drip tray,
the grounds container must be emptied, even if it
contains few grounds. if this is not done, when you
make the next coffees, the grounds container may fill
up more than expected and clog the machine.
•
Open the service door, remove the drip tray and
insert the grounds container.
•
Place pre-ground coffee in the funnel or deselect the
"pre-ground" function.
•
The descaling procedure described in the " Descaling"
section needs to be performed as soon as possible.
•
Select a milder taste or reduce the quantity of pre-
ground coffee.
•
Fill the beans container
•
Empty the funnel with the help of a brush as
described in the section "Cleaning the pre-ground
coffee funnel".
•
Insert the infuser as described in the paragraph
"Cleaning the infuser".
•
Close the service door.
•
Insert the milk container as far as it will go.
•
Press the CLEAN button and hold it down for at least
8 seconds. The message "Cleaning underWay" is
displayed.
•
Clean the inside of the appliance thoroughly, as
described in the section "Cleaning and maintenance".
if the message is still displayed after cleaning,
contact a service centre.
17
Advertisement
Table of Contents
Troubleshooting
