Table of Contents
Advertisement
19. DISPLAYED MESSAGES
DISPLAYED MESSAGE
Fill tank
Insert tank
Empty grounds container
Insert grounds container
Add pre-ground coffee
Fill beans container
Ground too fine
Adjust mill
Less coffee
Insert infuser assembly
POSSIBLE CAUSE
Insufficient water in the tank (A17).
The tank (A17) is not correctly in place.
The grounds container (A11) is full.
After cleaning, the grounds container (A11)
has not been replaced.
The "pre-ground coffee" function has been se-
lected without placing any pre-ground coffee
in the funnel (A4).
A LONG coffee with pre-ground coffee has
been requested
The coffee beans have run out.
The pre-ground coffee funnel (A4) is clogged.
The grinding is too fine and the coffee is deliv-
ered too slowly or not at all.
If the water softener filter (C4) is present, an
air bubble may have been released inside the
circuit, obstructing delivery.
Too much coffee has been used.
The infuser (A8) has not been replaced after
cleaning.
REMEDY
Fill the tank with water and/or insert it correct-
ly, pushing it as far as it will go until it clicks
into place (fig. 3B).
Insert the tank correctly and press as far as it
will go (fig. 3B).
Empty the grounds container and drip tray
(A15), clean and replace. Important: when
removing the drip tray, the grounds contain-
er must be emptied, even if it contains few
grounds. If this is not done, when you make
the next coffees, the grounds container may fill
up more than expected and clog the machine.
Remove the drip tray (A15) and insert the
grounds container.
Place pre-ground coffee in the funnel (fig. 10)
or deselect the "pre-ground" function.
Put one level measure of pre-ground cof-
fee into the pre-ground coffee funnel (A4)
and press OK (B3) to continue and complete
preparation.
Fill the beans container (A3) (fig. 7).
Empty the funnel with the help of a brush as
described in section "13.8 Cleaning the pre-
ground coffee funnel".
Repeat coffee delivery and turn the grinding
adjustment dial (A5) (fig. 6) one click clockwise
towards 7 while the coffee mill is in operation. If
after making at least 2 coffees delivery is still too
slow, repeat the correction procedure, turning
the grinding adjustment dial another click until
delivery is correct (see section "9.1 Adjusting the
coffee mill"). If the problem persists, make sure
the water tank (A17) is fully inserted.
Deliver a little water from the cappuccino
maker (A20) until it flows out normally.
Select a lighter taste by pressing
reduce the quantity of pre-ground coffee.
Insert the infuser as described in section "13.9
Cleaning the infuser").
20
(B7) or
Advertisement
Table of Contents
Troubleshooting
