CONTENTS 9.5 Making coffee using coffee beans ....14 9.6 Making coffee using pre-ground coffee ..14 1. FUNDAMENTAL SAFETY WARNINGS .....7 10. MAKING CAPPUCCINOS AND MILK-BASED 2. SAFETY WARNINGS ........8 COFFEES ..........15 2.1 Symbols used in these instructions ....8 10.1 Filling and attaching the milk container ..15 2.2 Designated use ..........8 10.2 Adjusting the amount of froth .....15 2.3 Instruction for Use .........8...
1. FUNDAMENTAL SAFETY WARNINGS • The appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
Any other use is considered improper and thus dangerous. The 2. SAFETY WARNINGS manufacturer is not liable for damage deriving from improper 2.1 Symbols used in these instructions use of the appliance. Important warnings are identified by these symbols. It is vital to respect these warnings.
In the App, you can also find information, tips and curious facts B9. Drinks available for selection (press the < or > scroll ar- rows to display all the drinks, the bottom bar indicates about the world of coffee, together with information on your which screen you are viewing) machine at your fingertips.
tween the surfaces of the appliance and the side and rear 5. “WATER CIRCUIT EMPTY PRESS OK TO START FILLING PRO- walls and at least 15 cm above the coffee maker. CESS” appears on the display; • Water penetrating the coffee maker could cause damage. 6.
• The message “TURNING OFF UNDERWAY PLEASE WAIT” 8.3 Water filter appears on the display, then (if envisaged) the appliance For instructions on how to install the filter (C4), see section “19. performs a rinse cycle and goes off (standby). Water softener filter”.
8.10 Coffee temperature 2. Press < (B10) or > (B8) until “ AUTO-START” appears on To modify the temperature of the water used to make the coffee, the display (B); proceed as follows: 3. Select the function by pressing ” ”.
4. Press “ ESC” to go back to the homepage. 3. Press “ “ and then “ OK” to restore the original pa- rameters (or “ ESC” to leave the parameters unaltered); 4. Press “ OK” to go back to the settings menu and “ 8.15 Background You can choose the display background from the following 4 al- ESC”...
6. Preparation begins. An image of the selected drink appears 9.3 Adjusting the coffee mill on the display (B) together with a progress bar which grad- The coffee mill is set by default to prepare coffee correctly and ually fills as preparation progresses. should not require regulating initially.
6. Preparation begins. An image of the selected drink appears on the display, together with a progress bar which gradual- 10.2 Adjusting the amount of froth ly fills as preparation progresses. Turn the froth adjustment dial (D1) to adjust the amount of froth Important! Making LONG coffee on the milk delivered while making cappuccinos and milk-based Halfway through preparation, the message “ADD PRE-GROUND...
• Preparation of each cappuccino or milk-based coffee can Choose CHOCOLATE from the homepage, then proceed as be customised (see sections “14. Customising the drinks” follows: and “15. Memorising your personal profile”). 1. Lift the carafe lid (E1) (fig. 23); •...
1. Make sure the hot water/steam spout (C6) is attached cor- Please note! rectly to the hot water/steam connection nozzle (A9); • If the hot chocolate powder used does not contain thicken- 2. Fill a container with the liquid to be heated or frothed and er, adjusting the density will have no effect.
6. Insert the nozzle and hot water/steam spout on the con- • “ GUEST” profile: when you select this profile, you can nection nozzle by pushing it upwards and turning it clock- deliver drinks with the default settings. The function wise until it is attached.
appliance cannot be used to make coffee until you have cleaned 16.5 Cleaning the inside of the coffee machine the grounds container (A10). Even if not full, the empty grounds Danger of electric shock! container message is displayed 72 hours after the first coffee has Before cleaning internal parts, the machine must be turned off been prepared.
Please note! If the infuser is difficult to insert, before insertion, adapt it to the 16.9 Cleaning the infuser right size by pressing the two levers shown in fig. 40. The infuser (A19) must be cleaned at least once a month. 8.
• You should use De’Longhi descaler only. Using unsuitable descaler and/or performing descaling incorrectly may re- sult in faults not covered by the manufacturer’s guarantee. Descale the appliance when “DESCALING NEEDED PRESS OK TO START (~40min) ”: appears on the display (B). To descale the appliance immediately, press “...
7. “PLACE 2l CONTAINER UNDER SPOUTS PRESS OK TO START 17. Hot water is delivered from the hot water/steam spout and DESCALING”: Place an empty container with a minimum “RINSING UNDERWAY” is displayed; capacity of 2 litres under the hot water/steam spout (C6) 18.
3. To change the level selected, press the symbol itself until 7. Extract the tank (A16) from the appliance and fill with the required level is displayed (Level 1 = soft water; Level 4 water. = very hard water); 8. “IMMERSE FILTER IN THE WATER TANK LETTING AIR 4.
19.3 Removing the filter 20. TECHNICAL DATA Replace the filter (C4) when “REPLACE WATER SOFTENER FILTER, Voltage: 220-240 V~ 50/60 Hz max. 10 A Power: 1450 W PRESS OK TO START ” appears on the display (B). To re- Pressure: 1,5 MPa (15 bar) place the filter immediately, press “...
Page 25
EMPTY GROUNDS CONTAINER The grounds container (A10) is full. Empty the grounds container and drip tray (A14), clean and replace. Important: when removing the drip tray, the grounds container MUST be emptied, even if it contains few groun- ds. If this is not done, when you make the next coffees, the grounds container may fill up more than expected and clog the machine.
Page 26
GROUND TOO FINE. ADJUST The grinding is too fine and the coffee is delive- Repeat coffee delivery and turn the grin- ding adjustment dial (A5) (fig. 13) one click MILL 1 CLICK WHILE IN red too slowly or not at all. clockwise towards “7”...
Page 27
PRESS OK TO START FILLING The water circuit is empty Press “ OK” to deliver water from the spout PROCESS (C6) until it flows out normally. If the problem persists, make sure the water tank (A16) is fully inserted. PRESS OK TO START CLEANING The milk container has been inserted with To proceed with the CLEAN function press “...
Page 28
REPLACE WATER SOFTENER FIL- The water softener filter (C4) is exhausted. Press “ OK” to replace or remove the filter, TER PRESS OK TO START or “ ESC” to carry out the procedure later. Follow the instructions in section “19. Water softener filter”.
TROUBLESHOOTING Below is a list of some of the possible malfunctions. If the problem cannot be resolved as described, contact Customer Services. PROBLEM POSSIBLE CAUSE SOLUTION The coffee is not hot. The cups were not preheated. Warm the cups by rinsing them with hot water (Please note: you can use the hot water function).
Page 30
The milk contains large bubbles and The milk is not cold enough or is not Use skimmed or semi-skimmed milk at refrige- squirts out of the milk spout (D5) or semi-skimmed. rator temperature (about 5° C). If the result is there is little froth not as you wished, try changing brand of milk.
24. ELECTRICAL REQUIREMENTS (UK ONLY) Before using this appliance ensure that the voltage indicated on the product corresponds with the main voltage in your home, if you are in any doubt about your supply contact your local electricity company. The flexible mains lead is supplied connected to a B.S. 1363 fused plug having a fuse of 13 amp capacity. Should this plug not fit the socket outlets in your home, it should be cut off and replaced with a suitable plug, following the procedure outlined below.