ZyXEL Communications SBG Series Support Notes page 15

7. Select Application Scenario
8. Select My Address
9. Enter Primary Peer Gateway Address
Configure Authentication information
1. Select Key Exchange Mode
2. Select Pre-Shared Key
Configure Phase 1
1. Enter SA Life Time
2. Select Negotiation Mode
3. Select Encryption
4. Select Authentication
5. Select Key Group
6. Enable the Dead Peer Detection (DPD)
Configure Phase 2
1. Enter SA Life Time
2. Select Tunnel Mode
3. Select Encapsulation
4. Select Encryption
5. Select Authentication
6. Enable Perfect Forward Secrecy (PFS)
Configure Policy
1. Select Local IP Type
2. Enter Local IP Address
3. Enter Local Subnet Mask
4. Select Remote IP Type
5. Enter Remote IP Address
6. Enter Remote Subnet Mask
7. Click on ―Apply‖.
SBG2:
Configure General information
1. Go to VPN >
2. Click on ―Add New Entry‖.
3. Check ―Enable‖.
―Site-to-Site‖.
―ADSL‖.
―Auto‖.
and enter 12345678.
86400.
―Main‖.
―AES192‖.
―SHA1‖.
―DH2‖.
86400.
―ESP‖.
―Tunnel‖.
―AES192‖.
―SHA1‖.
―Subnet‖.
192.168.1.0.
255.255.255.0.
―Subnet‖.
172.16.0.0.
255.255.0.0.
IPSec VPN > Setup.
ZyXEL – SBG Support Notes
10.59.3.20.
checkbox.
and select ―DH2‖.
Back to Table of Contents
15