Inlet Water Connections - Jenn-Air JDB9600CWS Installation Instructions Manual

Method B - To permanently connect to household
1. Remove the dishwasher electrical supply junction box
cover and connect to the power supply cord from the
house installation. See Figure 7.
2. Remove 2" to 3" (51 - 76 mm) of the outer casing of the
Remove 3/8" to 1/2" (10 - 13 mm) of the insulation from
each wire as shown in Figure 8.
Figure 8
(51mm - 76mm)
3/8" - 1/2"
(10mm - 13mm)
3. Insert the bare copper or green wire (ground) to the "G"
ground connection "
curely tighten the terminal block screw (see Figure 7).
4. Insert the white (neutral) wire to the "N" connection of
the terminal block and securely tighten the terminal block
screw.
5. Insert the black (hot) wire to the "L" connection of the ter-
minal block and securely tighten the terminal block screw.
6. Check all electrical connections to make sure they are
secure and then attach the junction box cover with the
4 screws.
Figure 8.
2" - 3"
" of the terminal block and se-

Inlet Water Connections

Hot Water Supply
The hot water heater should be set to deliver approximately
120° F (49° C) water to the dishwasher. Water that is too hot
can cause some detergents to lose effectiveness. Lower water
temperatures will increase run times. The hot water supply
pressure must be between 15 - 145 psi (1 - 10 bar).
IMPORTANT NOTES:
•
sure to make all solder connections before connecting
the water supply line to the dishwasher.
• Make sure there are no sharp bends or kinks in the water
line that might restrict water low.
• Always use the appropriate seal when making plumbing
connections.
• Before connecting the water supply line to the dishwasher,
lush the incoming water line for approximately 5 minutes
to clear any foreign material.
• Turn on the water supply and check for leaks after con-
nections are made.
WARNING
Avoid Scald Hazard
Do not perform any work on a charged hot water line.
should perform plumbing work. Do not attempt any
work on the dishwasher hot water supply plumbing
until you are certain the hot water supply is shut off.
CAUTION
Temperatures required for soldering and sweating will
damage the dishwasher. If plumbing lines are to be
soldered or sweated, keep the heat source at least 6
inches (152.4 mm) away from the dishwasher.
Water Supply Shut Off Valve
Install an easily accessible shut-off valve (not supplied)
in the hot water supply line, as shown in Figure 9. All
solder connections must be made before the water line
is connected to the dishwasher.
7