Electrical Preparation - Jenn-Air JDB9600CWS Installation Instructions Manual

Electrical Preparation

WARNING
Avoid Electrical Shock Hazard
Do not work on an energized circuit. Doing so could result
perform electrical work. Do not attempt any work on the
dishwasher electric supply circuit until you are certain the
circuit is de-energized.
To avoid possible injury or property damage, care should
be exercised when the dishwasher is installed or removed
to reduce the likelihood of damage to the power cord.
Avoid Fire Hazard
Make sure electrical work is properly installed. Only quali-
Make sure there are no loose electrical connections. Make
sure all electrical connections are properly made.
Electrical Supply
The customer has the responsibility of ensuring that the dish-
washer electrical installation is in compliance with all national
and local electrical codes and ordinances. The dishwasher
is designed for an electrical supply of 120V, 60 Hz, AC, con-
nected to a dishwasher-dedicated, properly grounded electri-
cal circuit with a fuse or breaker rated for 15 amps. Electrical
supply conductors shall be a minimum #14 AWG copper wire
rated at 75°C (167°F) or higher.
Grounding Instructions
The dishwasher must be properly grounded before operating.
This appliance must be connected to a grounded metal per-
manent wiring system, or an equipment grounding conductor
must be run with the circuit conductors and connected to the
equipment grounding terminal or lead on the dishwasher.
Make sure that the dishwasher is connected to a suitable
ground in compliance with all local codes or, in the absence
of a local code, with the NATIONAL ELECTRICAL CODE
in the United States or the CANADIAN ELECTRIC CODE
C22.1-latest edition in Canada as well as any provincial/state
or municipal or local codes that apply.
Dishwasher Electrical Rating
Volts Hertz
120 60
6
Electrical Preparation
Amperes Watts
12 1,300 (max)
Electrical Connection
The dishwasher electrical supply junction box (P) and
dedicated receptacle must be mounted in an accessible
cabinet adjacent to the dishwasher (do not mount the
junction box or receptacle behind the dishwasher). You
will need a 4 3/4 " x 2 3/8 " (120 x 60 mm) opening through
the cabinet in order to pass the junction box through (see
Figure 6). If the opening is made through wood, sand
it smooth. If the opening is made through metal, use
the included protective grommet (I) or other approved
method to protect wiring from damage. Use the four
screws included (or appropriate fastener) in the parts
bag to securely mount the junction box so that it can be
easily accessed (see Figure 6). The electrical supply
can be connected in two ways:
Dedicated
Receptacle
or
Field Wiring
Dishwasher
Electrical Supply
Junction Box
Figure 7
Method A - Three prong plug and receptacle
Use the included three-prong plug and junction box to
connect to a dedicated household receptacle. Make sure
the household receptacle meets the electrical supply
requirements as well as national and local codes.
Figure 6
Electric cord with
junction box and
three prong plug
are included
with dishwasher
P
CLICK