Table of Contents
Advertisement
You phone supports microSD cards of up to GB.
1. Open the cover of the memory card slot.
2. Insert the card into the memory card slot with the
contact surface facing down, and press until it locks
into place.
Remove the memory card
Important: Do not remove the memory card in the
middle of an operation when the card is being accessed.
Removing the card in the middle of an operation may
damage the memory card as well as the device, and data
stored on the card may be corrupted.
You can remove or replace the memory card card during
phone operation without switching the device off.
1. Ensure that no application is currently accessing the
memory card.
2. Open the cover of the memory card slot.
© 2008 Nokia. All rights reserved.
2
3. Press the memory card slightly in to release the lock,
and remove it.
Charge the battery
1. Connect the charger to a wall socket.
2. Connect the lead from the
charger to the charger
connector of your phone.
If the battery is completely
discharged, it may take a few
minutes before the charging
indicator appears on the display
or before any calls can be made.
The charging time depends on the charger used. Charging
a BL-5CT battery with the AC-3 charger takes
approximately 1 hour 30 minutes while the phone is in
the standby mode.
Antenna
Your device may have internal and external
antennas. As with any radio transmitting device,
avoid touching the antenna area unnecessarily
while the antenna is transmitting or receiving.
Contact with such an antenna affects the
communication quality and may cause the
device to operate at a higher power level than
otherwise needed and may reduce the battery
life.
Get started
13
Advertisement
Table of Contents
