Table of Contents
Advertisement
7.MEASURMENT OPERATION
p"Hold the meter by its Handle Grip and point it toward the surface
to be measured.
q"Pull and hold the Trigger to turn the meter on and begin testing.
The display will light if the battery is good. Replace the battery if
the display does not light.
r"While measuring, the SCAN display icon will appear ins the upper
left hand corner of the LCD.
s Release the Trigger and the HOLD display icon will appear on the
LCD indicating that the reading is being held.
t The meter will automatically power down after approximately 7
seconds after the trigger is released.(Unless the unit is locked on)
Note: Measurement considerations
Holding the meter by its handle, point the IR Sensor toward the object
whose temperature is to be measured. The meter automatically
compensates for temperature deviations from ambient temperature.
Keep in mind that it will take up to 30 minutes to adjust to wide
ambient temperatures are to be measured followed by high
temperature measurements, some time (several minutes) is required
after the low (and before the high) temperature measurements are
This is a result of the cooling process, which must take place for the IR
made.
sensor.
10
Advertisement
Table of Contents
