Miele KFN 37682 iD Operating And Installation Instructions page 91

Installing the appliance.
 Push the appliance into the niche un‐
til all fixing brackets are in line with
the front edge of the furniture side
wall.
–  With 16 mm thick walls:
The spacers should touch the front
edge at the top and bottom of the
side walls of the housing unit.
–  With 19 mm thick walls:
The front edges of the top and bot‐
tom hinges should be flush with the
front edge of the housing side wall.
Installing the appliance
 Check the position of the fixing
bracket at the top and bottom front
edge of the furniture side wall again.
This will create a gap all round of 42
mm to the front edges of the housing
unit side walls.
On furniture with door fittings (e.g.
stubs, seals etc.) the dimension of
these must be taken into account
when making sure there is a gap all
round of 42 mm.
 Pull the appliance forwards by the
appropriate dimension.
The hinges and covers will now pro‐
trude by the dimension of the door fit‐
ting.
Tip: Remove the door fittings. This will
ensure that the door is flush with the
surrounding kitchen unit furniture
doors.
  Align the appliance on both sides
by altering the adjustable feet using
the spanner supplied.
If the all round gap of 42 mm is not
maintained between the appliance
housing and the front edge of the
housing unit side wall, the door may
not shut properly.
This can cause ice to build up, con‐
densate to accumulate and lead to
faults in the appliance. These can all
lead to increased energy consump‐
tion.
91