Maintenance; Service Position - Ariens Pro 28 Owner's Manual

Ariens Dealers will provide any service or
adjustments which may be required to keep
your unit operating at peak efficiency. Should
engine service be required, contact an Ariens
dealer or an authorized engine
manufacturer's service center.
WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.

SERVICE POSITION

(Figure 16)
WARNING: Before tipping unit up
onto housing, remove fuel so no
spills will occur. Ensure unit is
secure and will not tip over during

maintenance.

1. Shut off engine, remove key, disconnect
spark plug wire and allow unit to cool
completely.
2. Close fuel shut-off valve (see Fuel Shut-
Off Valve on page 19).
3. Drain fuel tank and fuel system (see
Engine Manual for complete
instructions).
4. Place unit on a flat level surface. Tip unit
forward onto front of auger housing for
service.
IMPORTANT: Ensure unit is secure and will
not tip over. Strap and clamp onto bench if
needed.
Figure 16
MAINTENANCE
Service Position
MAINTENANCE SCHEDULE
The chart below shows the recommended
maintenance schedule that should be
performed on a regular basis. More frequent
service may be required.
MAINTENANCE
Service
Performed
Check Dual
Handle
Interlock
Check
Fasteners
Check Clutch
Operation
Clean Engine
Check Engine
Oil
Check Clutch
Cable
Adjustment
Change
Engine Oil **
Check Tire
Pressure
Check Auger
Gearcase
General
Lubrication
*
After first five hours of operations.
**
Refer to Engine Manual for detailed
instructions.
CHECK DUAL HANDLE
INTERLOCK
Without the engine running, press down
(engage) both clutch levers. Release
attachment clutch lever. Attachment clutch
should remain engaged until traction clutch
lever is released, then both clutches must
disengage.
CHECK FASTENERS
Make sure all hardware is tightened properly.
EN - 21
SCHEDULE
•
•
•
•
• •
* •
•
• •
• •