Connecting The Signal Cable - Diamond View 2115E User Manual

Connecting the Signal Cable

Your 2115E monitor provides both 15 pin VGA type (D-SUB) and BNC signal
connectors. The D-SUB or BNC signals are automatically detected by the monitor.
Connecting through D-SUB signal connector
1) Make sure that the system power is turned off.
2) Connect the computer end of the D-SUB cable to the 15-pin output connector
on the video board of your computer.
3) Connect the monitor end of the BNC signal cable to the BNC plugs at the
back of the monitor. Make sure that you connect each plug to the correct
socket.
5