Starting The Engine; Stopping The Engine - Honda WDP30X Owner's Manual

STARTING THE ENGINE

1. Turn the fuel valve to
the ON position.
2. Move the choke lever
to the CLOSED
position.
Do not use the choke
if the engine is warm
or the ambient
temperature is high.
3. Turn the ignition
switch to the ON
position.
4. Move the throttle
lever slightly to the
left.
5. Pull the starter grip
lightly until resistance
is felt, then pull it
briskly.
NOTICE
Return the starter grip
slowly back to the
engine to prevent
damage to the starter.
STARTER GRIP
6. As the engine warms
up, gradually move
the choke lever to the
OPEN position.
6
FUEL VALVE
ON
CHOKE LEVER
CLOSED
IGNITION
SWITCH
THROTTLE LEVER
CHOKE LEVER
OPEN
7. Set the throttle to the
desired speed to
produce the best
pumping conditions.
Pump output can be
controlled by adjusting
the throttle lever to the
desired position.
At FULL throttle position, the pump will deliver the highest output
volume. Moving the throttle toward the IDLE position will decrease
the output volume of the pump.

STOPPING THE ENGINE

Emergency
To stop the engine in an
emergency, turn the
ignition switch to the OFF
position.
ON
Normal
1. Move the throttle lever
fully to the right to the
IDLE position.
2. Turn the ignition switch
to the OFF position.
3. Turn the fuel valve to
the OFF position.
4. If the pump is not going
to be used again for the
rest of the day, or is
going to be stored for a
long period of time,
refer to page 16 for
procedures on properly
storing your pump.
5. After each use, drain the pump chamber and flush with fresh water
(page 12).
THROTTLE LEVER
FULL
IGNITION
SWITCH
THROTTLE LEVER
FUEL VALVE
OFF
IDLE
OFF
IDLE