Using The Optical Disc Drive; Changing The Sleeve - Dell Studio Hybrid DCSEA Setup Manual

Using Your Studio Hybrid

Using the Optical Disc Drive

NOTICE: Do not use non-standard-size or
shape discs (including mini-CDs and mini-
DVDs) or you will damage the drive.
12 cm
NOTE: Do not move the computer while
playing or recording CDs and DVDs.
Place the disc in the center of the disc slot, with
the label facing outwards and gently push the
disc into the slot. The drive will automatically
pull the disc in and begin reading its content.
To eject a disc from the drive, gently
touch the eject control. The control will flash to
confirm a few seconds before ejecting the disc.
20

Changing the Sleeve

You can use different sleeves to personalize
your computer's appearance.
NOTE: You can purchase additional sleeves
from the Dell website at dell.com.
To change your computer's sleeve:
1. Place the computer horizontally on a clean
flat surface such as a mat to avoid scratches
and remove the screw.
Using Your Studio Hybrid
2. Place the computer vertically and pull the
sleeve gently towards the back of your
computer, then gently slide the new sleeve
onto the computer.
3. Place the computer horizontally again and
replace the screw by inserting it at an
approximately 45-degree angle and gently
turning the screw.
21