No. Part name
Heat
11
1. Detachment
exchanger
1) Recover the refrigerant gas and then
2) Perform works of 1 of
3) The screw that is the fixing of the piping
4) The screw of the partition plate is
5) The screw of the heat exchanger on the
2. Attachment
1) Attach as before in heat exchanger
2) Connect the refrigerant pipe as original, and
SVM-13085.indb 98
SVM-13085.indb 98
Procedure
remove the refrigerant pipe of the
indoor unit.
9
.
Pull out sensor wires from the holder.
support is removed, and the piping
support is removed. (Ø4 x 10, 2 pcs.)
removed while holding the heat
exchanger, the partition plate is removed.
(Ø4 x 10, 4 pcs.)
partition plate and the other side is
removed while holding the heat exchanger,
and the heat exchanger is removed.
sensor
piping support
drain pan
under panel order.
then perform vacuuming.
– 98 –
FILE NO. SVM-13085
Remarks
Screws
Fixing plate
Screws
Screws
12/24/13 10:56 AM
12/24/13 10:56 AM