Advanced Setup - ECS G31T-M7 Manual

30

Advanced Setup

This page sets up more advanced information about your system. Handle this page
with caution. Any changes can affect the operation of your computer.
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
Thermal Management
TM Status
Max CPUID Value Limit
Enhanced Halt (C1E)
Intel XD Bit
Intel EIST
Inter Virtualization Technol
Quick Power on Self Test
Boot Up Numlock Status
APIC Mode
1st Boot Device
2nd Boot Device
3rd Boot Device
Hard Disk Drives
Removable Drives
CD/DVD Drives
Boot Other Device
Thermal Management (Enabled)
This item displays CPU's temperature and enables you to set a safe temperature to
Prescott CPU.
TM Status (TM1/TM2)
This item displays CPU Monitor status.
Max CPUID Value Limit
Use this item to enable or disable the Max CPU ID value limit. When suppports
Prescottand LGA775 CPUs, enables this to prevent the system from
"rebooting" when trying to install Windows NT 4.0.
Enhanced Halt (C1E) (Enabled)
This item enables or disables enhanced halt (C1E).
Intel XD Bit (Disabled)
This item allows users to enable or disable the Intel XD bit.
Intel EIST (Enabled)
This item allows users to enable or disable the EIST
technology).
Intel Virtualization Technol (Enabled)
When enabled, a VMM can utilize the additional hardware capabilities provided by
Vandor Pool Technology.
Quick Power on Self Test (Enabled)
Enable this item to shorten the power on testing (POST) and have your system start
up faster. You might like to enable this item after you are confident that your system
hardware is operating smoothly.
Boot Up Numlock Status (On)
This item defines if the keyboard Num Lock key is active when your system is
started.
Advanced Setup
Enabled
TM1/TM2
Disabled
Enabled
Disabled
Enabled
Enabled
Enabled
On
Enabled
ST3320620AS
BENQ DVD DC DW1810
1st FLOPPY DRIVE
Press Enter
Press Enter
Press Enter
Yes
: Move Enter : Select
+/-/: Value F10: Save
F1:General Help F9: Load Default Settings
(Disabled)
Using BIOS
Help Item
For the processor its
CPUID belows 0F14h.
TM2 only can be enable
under below settings.
1.Freq.>=3.6GHz FSB800
2.Freq.>=2.8GHz FSB533
ESC: Exit
Enhanced Intel SpeedStep
(