Stopping Your Engine And Short-Term Storage - Tecumseh OHV 110 Operator's Manual

Four-cycle, vertical crankshaft, air-cooled
Hide thumbs Also See for OHV 110:
Table of Contents

Advertisement

II. Independent Speed and Choke Controls
1. To avoid carbon monoxide poisoning, make sure
engine is outdoors in a well-ventilated area.
2. Move engine speed control to "FAST" position and set
choke control to "FULL CHOKE" position (see equip-
ment manufacturer's instructions). See Figures 13, 15,
16 and 17.
Generator and Water Pump applications may have the
choke lever mounted on the engine. See Figure 17.
If restarting a warm engine after a short shutdown, move
Speed Control to "FAST" position and move Choke Control
to "NO CHOKE" position.
When pulling starter rope, the rope
WARNING
!
can unexpectedly jerk back toward
engine causing serious injury. To avoid this risk, carefully
follow these instructions:
3. Grasp starter cord handle. See Figure 14.
a. Pull rope out slowly until you feel drag.
b. Without allowing the rope to retract, continue
pulling rope with one rapid full arm stroke.
c. Return rope slowly to original position.
Following the instructions listed in the steps above avoids
potential damage to the recoil mechanism.
If engine fails after 3 pulls repeat steps 2 thru 3.
4. When engine starts:
a. Move choke control to "1/2 CHOKE" position until
engine runs smoothly.
b. Next, move control to "NO CHOKE" position.
5. Move speed control to desired speed in "RUN" range.
If engine starts but falters when choke is moved to "NO
CHOKE" position:
a. Momentarily move choke control back to "FULL
CHOKE" position.
b. Next, move control to "1/2 CHOKE" position until
engine runs smoothly.
c. Finally, move control to "NO CHOKE "position.
If engine dies after choke control is moved to "NO CHOKE"
position repeat steps 2 thru 5 to restart engine.
6. If engine fires but does not continue to run, move
choke control to "NO CHOKE" position and pull starter
rope again.
7. If engine fails to start after 3 attempts in the "NO
CHOKE" position, move choke control to "FULL
CHOKE" position and pull starter rope again.
8. If engine does not start after following steps 1 thru 7,
contact your Authorized Tecumseh Servicing Dealer.
DO NOT attempt to start or troubleshoot this engine in
any other way.
181-1132-14
NOTES
NOTE
NOTES
Four-Cycle • Vertical Crankshaft • Air-Cooled
Choke
Control
Figure 15. Independent Speed and Choke Controls
1. No Choke
2. 1/2 Choke
3. Full Choke
Figure 16. Choke Control Positions
1
1. No Choke
2. 1/2 Choke
3. Full Choke
Figure 17. Engine Mounted Choke Lever
VI. Stopping Your Engine and
Short-Term Storage
Stop engine according to equipment manufacturer's
instructions.
To avoid unsupervised operation of
WARNING
!
an engine, especially by children,
NEVER leave it unattended when it is running. Always turn
off the engine after use and remove ignition key if provided.
Never store the engine with fuel in
WARNING
!
the fuel tank inside a building with
potential sources of ignition such as hot water and space
heaters, clothes dryers, electric motors, etc.
Speed
Control
1
2
3
2
3
Page 9

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ohv 135

Table of Contents