Assembling The Ice Cream Maker; Switching On The Ice Cream Maker; Pouring In The Ice Cream Mass - Delta GT-EM-02 User Manual

Assembling the Ice Cream Maker

Hazard! Switch the appliance off and disconnect the mains plug
prior to all assembly activities.
1. Place the motor block (1) on the lid (2) in the designated fi xing. You will hear a
"click" sound when the motor block (1) is in the right position.
2. Insert the connector (5) into the motor block (1) from below.
3. Now, you can slide the stirring paddle (4) onto the connector (5). Ensure that the
stirring paddle (4) locks in, so that a proper fi t is guaranteed.
Warning: Only touch the frozen freezer bowl (3) with pot
holders or oven gloves, in order to avoid frostbite.
4. Only remove the freezer bowl (3) from the freezer directly prior to preparing ice
cream.
Important: Do not pour in the ice cream mass yet!
5. Place the lid (2) with the motor block (1) on the freezer bowl (3). Turn the lid (2)
slightly anti-clockwise, as far as it goes.

Switching on the Ice Cream Maker

Important: Do not pour in the ice cream mass yet!
• Press the on/off switch (6) into position I to switch on the Ice Cream Maker. The
stirring paddle (4) will begin to rotate.

Pouring in the ice cream mass

Important: Only pour an amount of ice cream mass into the
freezing bowl (3), so that at least 2.5 cm remains free at the
rim. When freezing, the mass moves upwards and therefore
requires more space.
1. Pour the prepared and well-chilled ice cream mass through the fi lling shaft of the
running Ice Cream Maker.
Helpline No. UK/Northern Ireland 0800 328 6020 Rep. Ireland 00800 4467 5888
E-mail Support info@dariolondon.com
Model Number: GT-EM-02
11