oset 20.0 Eco Owner's Manual page 21

- With the wheel raised, pull the brake lever. This will allow the caliper to 'center'
on the disc.
- With the lever still holding the pads tightly on the disc, re-tighten the caliper
bolts.
- If the wheel does not spin freely with the brake released and further adjustment
is required beyond the limits of the built in adjustment, the caliper position itself
can be adjusted further by the use of spacer washers. In this way, the caliper
can be lined up perfectly.
Loosen caliper.
Inspect pads.
- The brake levers can be adjusted for 'reach'. Use a small 2mm Allen key. Turn
anti-clockwise to bring the reach closer to the bar (for smaller hands).
NOTE:
Brake pads should be inspected regularly for wear and replaced when
necessary.
The brakes are hydraulic. Fluid should be checked regularly and only the correct
fluid used to top up.
Any 'drag' in the system will affect performance, and wear out components and
brake pads more quickly.
Squeeze lever
Adjust lever reach.
20