Miele KM 6112 Operating And Installation Instructions page 48

Problem solving guide
Problem
The food in the pan
does not heat up when
the Auto heat-up func‐
tion is switched on.
An operating noise can
be heard after the appli‐
ance has been switched
off.
The sensors show in‐
creased sensitivity or
fail to react.
The hob does not
switch off and  flashes
in the cooking zone dis‐
plays.
48
Cause and remedy
A large amount of food is being heated up.
 Start cooking at the highest power level and then
turn down to a lower one manually later on.
The pan is not conducting heat properly.
 Use a different pot or pan which conducts heat
properly.
The fan will continue running until the appliance has
cooled down. It will then switch itself off automatical‐
ly.
The sensitivity level of the sensors has changed.
 Make sure that there is no direct light (from the
sun or from an artificial source) falling onto the
hob. The area surrounding the hob must not be
too dark.
 Make sure that there is nothing covering the sen‐
sors or the hob.
Take any pans off the hob and wipe away any
food deposits.
 Interrupt the power supply to the hob for approx. 1
minute.
 If the problem persists after power has been re‐
stored, please contact Miele.
One or more of the sensors are covered, e.g. by fin‐
ger contact, food boiling over or an object.
 Remove the obstruction and/or clean the hob.