Table of Contents
Advertisement
DT Etherlink IV
NTU-2: Enter in a NTU device with the Monitor (LCT, RS-232 or USB) or Telnet interface.
Type following commands
3 <>
<DEFAULT EVERYTHING> <>
<MASTER OFF 1> <>
<MASTER OFF 2> <>
<MASTER OFF 3> <>
<MASTER OFF 4> <>
<PAYLOAD WAN 1> <>
<PAYLOAD WAN 2> <>
<PAYLOAD WAN 3> <>
<PAYLOAD WAN 4> <>
<NET> <>
<SETIP 10.0.2.201> <>
<NETMASK 255.0.0.0> <>
<GATEWAY 10.0.0.101> <>
<M> <>
<M> <>
2 <>
<APPLY ALL> <>
<CONFIRM> <>
In Menu Configuration Management (CM) you can type <CONFIG> to see the following picture:
CP_CM>CONFIG
--------------------------------------------------------------------------------
Running Line Configuration
--------------------------------------------------------------------------------
xDSL
DSL1
Mode
:
Slave(HTU-R)
Extended rates:
OFF
Line coding
:
PAM32
Baserate
:
89
Annex
:
B
Payload
:
WAN
Clock source
:
Int
GS compatible :
OFF
--------------------------------------------------------------------------------
CP_CM>
The idea is the following: the default settings help any device to be in an initial state, then the
MASTER/SLAVE mode is enabled on the modem, then the transmit data is configured, then the
network settings are configured (IP address, default subnet mask and default gateway) and finally,
these settings are applied and then are written in the EEPROM.
ATTENTION
DON'T FORGET TO WRITE THE CONFIGURATION IN THE STARTUP
CONFIGURATION WITH THE FOLLOWING COMMANDS:
2 <>
<APPLY ALL> <>
<CONFIRM> <>
User Manual
Description
Go to Configuration Management (CM)
Set everything to default configuration
Configure SHDSL 1 as SLAVE
Configure SHDSL 2 as SLAVE
Configure SHDSL 3 as SLAVE
Configure SHDSL 4 as SLAVE
Configure Ethernet over SHDSL 1
Configure Ethernet over SHDSL 2
Configure Ethernet over SHDSL 3
Configure Ethernet over SHDSL 4
Go to NET menu
Set the IP-address of the device
Set the subnet mask
Set the default gateway
Go to Configuration Management (CM)
Go to Main Menu
Go to Fault and maintenance management (FMM)
Apply all configurations (written in the running config.)
Confirm all configurations (written in the startup config.)
DSL2
DSL3
Slave(HTU-R)
Slave(HTU-R)
OFF
OFF
PAM32
PAM32
89
89
B
B
WAN
WAN
Int
Int
Go to Fault and maintenance management (FMM)
Apply all configurations (written in the running config.)
Confirm all configurations (written in the startup config.)
- 98 -
DSL4
Slave(HTU-R)
OFF
PAM32
89
B
WAN
Int
Advertisement
Table of Contents
