Table of Contents
Advertisement
DT Etherlink IV
NTU-1: Enter in a NTU device with the Monitor (LCT, RS-232 or USB) or Telnet interface.
Type following commands
3 <>
<DEFAULT EVERYTHING> <>
<MASTER ON 1> <>
<MASTER ON 2> <>
<MASTER ON 3> <>
<MASTER ON 4> <>
<PAYLOAD WAN 1> <>
<PAYLOAD WAN 2> <>
<PAYLOAD WAN 3> <>
<PAYLOAD WAN 4> <>
<NET> <>
<SETIP 10.0.2.200> <>
<NETMASK 255.0.0.0> <>
<GATEWAY 10.0.0.101> <>
<M> <>
<M> <>
2 <>
<APPLY ALL> <>
<CONFIRM> <>
In Menu Configuration Management (CM) you can type <CONFIG> to see the following picture:
CO_CM>CONFIG
--------------------------------------------------------------------------------
Running Line Configuration
--------------------------------------------------------------------------------
xDSL
DSL1
Mode
:
Master(HTU-C) Master(HTU-C) Master(HTU-C) Master(HTU-C)
Line coding
:
PAM32
Baserate
:
89
Annex
:
B
Payload
:
WAN
Clock source
:
Int
GS compatible :
OFF
--------------------------------------------------------------------------------
CO_CM>
User Manual
Description
Go to Configuration Management (CM)
Set everything to default configuration
Configure SHDSL 1 as MASTER
Configure SHDSL 2 as MASTER
Configure SHDSL 3 as MASTER
Configure SHDSL 4 as MASTER
Configure Ethernet over SHDSL 1
Configure Ethernet over SHDSL 2
Configure Ethernet over SHDSL 3
Configure Ethernet over SHDSL 4
Go to NET menu
Set the IP-address of the device
Set the subnet mask
Set the default gateway
Go to Configuration Management (CM)
Go to Main Menu
Go to Fault and maintenance management (FMM)
Apply all configurations (written in the running config.)
Confirm all configurations (written in the startup config.)
DSL2
DSL3
PAM32
PAM32
89
89
B
B
WAN
WAN
Int
Int
- 97 -
DSL4
PAM32
89
B
WAN
Int
Advertisement
Table of Contents
