HP ProLiant DL100 G2 Installation Instructions page 3

1 Slide rail installation
NOTE: Depending on the rail kit provided, your slide rail
assemblies may vary slightly from those in the following illustrations.
1. Install the slide rails to the rack as shown.
• For hardware-mounted rails (A), mount the rails onto the rack
using the supplied screws and star washers. For square-hole
racks, use the provided locator washers.
• For click-and-snap rails (B), hook the rails onto the rack. At both
ends of the rail, push the outer spring latch 1, and then slide
the spring mechanism toward the rail end until the rail is
secure 2.
1
2
IMPORTANT: For hardware-mounted assemblies, HP
recommends leaving the screws loose until the server is completely
installed. This eases installation by preventing binding of the server in
the rack.
A
B
5201A
2. Locate the inner slide rails:
• On hardware-mounted assemblies, remove the inner slide rails
from the outer slide rails. To do so, extend the inner slide rails
from the front of the rack until they lock in place. Then, press the
inner slide lock down, as shown, and pull the inner slide rails
straight out.
.
• On click-and-snap assemblies, the inner slide rails arrive
separately from the outer slide rails.
2 Server preparation
1. Attach the two thumbscrew brackets to the server using the supplied
bracket screws, as shown 1.
2. Attach a slide rail (lock facing out) to each side of the server, insert
the slide rail screws through the slide rails, and then tighten, as
shown 2.
3. Attach the bezel 3 to the thumbscrew brackets, and then lock bezel
to server (if desired).
2
1
3
10685
2
1
5202