HP ProLiant DL100 G2 Installation Instructions page 2

Front and Rear Views
3
1 2
1 Slim DVD-ROM
2 Individual HDD status LED
3 2 USB ports
4 Overall HDD activity LED
5 Overall HDD fault LED
6 NIC LEDs
7 UID LED
8 Power LED
9 UID button
10 Power button
11 HDD bays (0-3)
1 2 3 4 5
10
8 9
1 Dual USB port
2 PS/2 mouse port
3 NIC connectors (RJ45)(1-2)
4 UID LED
5 Low profile, half length PCI-X slot
6 Full height, full length PCI-X slot
7 AC power connector
8 PS/2 keyboard port
9 Serial port
10 D-sub VGA port
1. Slide rail assemblies vary. The click-and-snap assemblies hook onto the
rack. The hardware-mounted assemblies attach to the rack using supplied
screws, star washers, and locator washers.
4 6 8 10
5 7 9
11
6 7
Warnings and Cautions
WARNING!
sufficiently stable. If provided, lower the rack leveler feet and make
sure any required stabilizers are installed. If provided, extend the rack
anti-tip device. Failure to extend the anti-tip device could result in
personal injury or damage if the rack tips over.
CAUTION:
in the rack have a reliable ground connection. Verify that the total
current of the rack components does not exceed the current rating of
the power distribution unit or outlet receptacles.
Rack planning procedures
10699
The rack resource kit ships with all HP branded or Compaq branded
9000, 10000, and H9 series racks. For more information on the
content of each resource, see the rack resource kit documentation.
If you intend to deploy and configure multiple servers in a single rack,
refer to the white paper on high-density deployment at the following
HP web site:
www.hp.com/products/servers/platforms
10700
Before you begin, make sure that the rack is
Make sure that the rack and all equipment mounted