Installing The Battery - TOHATSU M 25H Owner's Manual

Connecting the Cord Assembly
(Wiring Harness)
Pass the cord assembly from the
remote control through the hole in
the bottom cowl and connect the
electric terminals and then clamp
the cord assembly according to the
drawing below.
Cord ass y
Cord ass y
Magnet lead wire
!
Do not d sconnect the cord assemb y
when the outboard motor s n
operat on or you w
outboard motor.
Cord ass y
Cord ass y
ose contro of the

3. Installing the battery

Place the battery box in a convenient
position away from possible water
spray. Securely fasten both the box
and the battery so they do not shake
loose.
Note
Minimum recommended battery :
12V, 70AH (465 Marine Cranking
Amps (MCA) or 350 Cold Cranking
Amps (CCA)) Specifications and
features of batteries vary among
the manufacturers. Consult the
manufacturer for details.
!
Battery e ectro yte conta ns su fur c
ac d and thus s hazardous, caus ng
a burn f t comes n contact w th your
sk n, or po sonous f swa owed.
KEEP BATTERY AND ELECTROLYTE
AWAY FROM REACH OF CH LDREN
When hand ng the battery, be sure to:
• Read a warn ngs shown on the
battery case
• Prevent e ectro yte from com ng n
contact w th any part of your body.
Contact can cause ser ous burn or,
f t comes n contact w th your eye,
oss of s ght. Use safety g asses
and rubber g oves.
n case battery e ectro yte comes n
contact w th:
• Sk n, flush thorough y w th water.
• Eye, flush thorough y w th water,
and then seek mmed ate med ca
treatment.
n case battery e ectro yte s
swa owed:
• Seek mmed ate med ca treatment.
INSTALLATION