Fixing Instructions; You Will Need; Fixing Procedure; Product Guarantee - Arcam Solo bar Handbook

fixing
instructions
Use the custom-designed wall mount accessory to
attach the Solo bar safely and securely to a wall.

You will need

Fixing procedure

Power drill 1. Make sure the wall bracket is horizontal
<
Drill bit, wall plugs and fixings suitable by placing a spirit level underneath it.
<
for the type of wall you are fixing to.
Screw driver 2. Mark the holes with a pencil, taking
<
Spirit level care to trace the outlines accurately.
<
< Pencil
Tape measure 3. Carefully drill four holes, using a drill
<
bit and plugs suitable for the type of
wall you are fixing to.
Make sure the wall mount is horizontal.
4. Attach the wall mount to the wall using Caution: Do not mount the unit on
four robust screws (the screw should plywood or any soft surface walls. If you
have a minimum diameter of 5.5mm), are uncertain of the wall quality, consult
making sure they fit the wall plugs a professional for advice.
correctly and are done up tight and
evenly.
5. Finally, attach the Solo bar to the wall
mount by carefully guiding it onto the
two protruding supports. It should sit
firmly and securely against the wall.
200.0
Make sure the screws are tight and flush
before guiding the Solo bar down onto the
two protruding supports. It should sit
securely against the wall.
E-24
product
guarantee

Copyright

Worldwide guarantee

June 2014, © 2014 A&R Cambridge Ltd. Arcam warrants that the products
described in this guide shall conform to
A & R Cambridge Limited (Arcam) their published specification in all material
reserves the right to make changes to the respects for a period of two years from the
specifications of the products detailed in date of purchase. This entitles you to have
this document at any time without notice the unit repaired free of charge, provided
or obligation to notify any person of such that it was purchased from an authorised
changes. Arcam dealer.
All third-party trademarks are The Arcam dealer is responsible for all
acknowledged and observed. Mention of after-sales service. The manufacturer can
third-party products does not constitute an take no responsibility for defects arising
endorsement or a recommendation. from accident, misuse, abuse, wear and tear,
neglect or through unauthorised adjustment
Arcam takes every precaution to ensure that and/or repair, neither can they accept
all information contained in this publication responsibility for damage or loss occurring
is factually correct but accepts no liability during transit to or from the person
for any error or omission. claiming under the guarantee.
The warranty covers:
Parts and labour costs for two years from
the purchase date. After two years you must
pay for both parts and labour costs. The
warranty does not cover transportation
costs at any time.

Claims under guarantee

Problems?

This equipment should be packed in the If your Arcam dealer is unable to answer
original packaging and returned to the any query regarding this or any other Arcam
dealer from whom it was purchased.
product please contact Arcam Customer
It should be sent carriage prepaid by a Support at the address below and we will do
reputable carrier – not by post. our best to help you.
No responsibility can be accepted for Arcam Customer Support Department,
the unit whilst in transit to the dealer or Unit 15, Pembroke Avenue,
distributor and customers are therefore Waterbeach, CAMBRIDGE,
advised to insure the unit against loss or CB25 9QP, England or via
damage whilst in transit. www.arcam.co.uk.

On-line registration

You can register your product on-line at
www.arcam.co.uk.
E-25