System Setup; System Setup Menu; Speaker/Eq Setup Menu - Arcam Solo bar Handbook

system setup

Use the remote control and follow these steps to ensure
your Solo bar is set up for maximum enjoyment.

System setup menu

Default settings are shown in Blue.
System Setup Lipsync Delay
Display Level
App Control
IR Repeater
System Info
Factory Defaults
0 to 200ms Delays may be introduced into the video signal by video
processing which causes a mismatch between the audio and
video timing. You will notice this by speech sound being out
of synch with lip movements. To compensate for this, you can
adjust the lip sync delay. Use the and
synchronisation between sound and vision. Press
back a level or to exit setup.
Dim g Bright g Off The LED display levels can be adjusted to suit your
requirements. Use the and buttons to switch between
settings. When set to Off, the display illuminates briefly
whenever it receives a command. Press
to exit setup.
Enable g Disable Enables the Solo bar to be woken from standby using the
optional remote control app. Use the
switch app control on or off. Press to go back a level or
to exit setup.
Enable g Disable
Use the and buttons to switch IR repeater on or off.
See page 16 for more information. Press
to exit setup.
Press OK to view the system software version.
Press OK to reset the Solo bar to factory defualts. Note: Paired or connected devices will be lost.
Press to go back a level or to exit setup.
E-18

Speaker/EQ setup menu

Default settings are shown in Blue.
buttons to adjust
to go
to go back a level or
and buttons to
to go back a level or
Speaker/EQ Setup Auto Setup Auto setup configures your Solo bar for optimum listening experience Press OK to start setup
procedure. See page 17 for more information.
Room EQ Enable g Disable
Sub Pairing
Press to start pairing procedure. See page 10 for more information.
Subwoofer Level 0 to -12dB
Headphone out
BT Transmitter
Enable g Disable
Device search
E-19
Use the and buttons to switch EQ on or off.
Note: Only available after Auto setup has been completed.
Press to go back a level or to exit setup.
Use the and buttons to select a subwoofer level.
Note: Only available after Sub Pairing has been completed.
Press to go back a level or to exit setup.
Use the and buttons to switch Bluetooth® transmitter
on or off. Press to go back a level or to exit setup.
Note: Only available if headphone out is enabled.
Press to start searching for headphones. Use and
buttons to select headphone from list. Press to go back a
level or to exit setup.