Advanced New Message Alerting Features - Panasonic KX-TGE220AZ Operating Instructions Manual

Answering System
Using the Smart Function Key
When is displayed and the
flashes slowly, there are new messages.
Press M N in step 1 on "Using the handset",
page 41.
R "New Message" must be set to "On" in
"Setting the Smart Function Key", page 14.
Operating the answering system
MMENUN a a MOKN
Key Operation
MjN or MkN Adjust the receiver or speaker
volume (during playback)
1 or MFN Repeat message
(during playback)
2 or MEN Skip message
(during playback)
3 Enter the "Settings" menu
4 Play new messages
5 Play all messages
6 Play greeting message
76 Record greeting message
8 Turn answering system on
MMENUN
Pause message
9 or Stop recording
MSTOPN Stop playback
0 Turn answering system off
*3 Erase currently playing
*4
message
*5 Erase all messages
*6 Reset to a pre-recorded
greeting message
*1 If pressed within the first 5 seconds of a
message, the previous message is
played.
*2 To resume playback:
MbN: "Play" a MOKN
*3 You can also erase as follows:
MMENUN a MbN: "Erase" a MOKN a
MbN: "Yes" a MOKN
42
TGE2xxAZ_(en-en)_0522_ver.023.pdf
Calling back (Caller ID subscribers
only)
indicator
1
Press MMENUN during playback.
2
MbN: "Call Back" a MOKN
n Editing the number before calling back
1
Press MMENUN during playback.
2
MbN: "Edit & Call" a MOKN
3
Edit the number. a M
Erasing all messages
1
MMENUN#325
2
MbN: "Yes" a MOKN a M
*1
Advanced new message
alerting features
Audible message alert
This feature allows the base unit to beep to
inform you of a new message arrival when
new messages are recorded. The base unit
beeps 2 times every minute until you listen to
the messages, if the "Base Unit Beep"
*2
setting is turned on. The default setting is
"Off".
1
MMENUN#339
2
MbN: Select the desired setting. a MOKN
a M
New message alert by a call
This feature allows you to receive a
notification by phone when new messages are
recorded. The base unit calls a phone number
you specify. You can then operate the
answering system remotely to listen to the
new message.
To use this feature, you must:
– store a phone number to which the unit
makes the call to.
– turn on the new message alert setting.
42
N
N
N
2014/05/22 13:30:27