Advertisement
VALVE ACTUATORS
Your control system is designed to activate two motorized valves which
automatically rotate between pool and spa filtration whenever the SPA Switch is
activated at the Remote Control.
The valves are also activated from the "FILL" and "DRAIN" positions of the SPA
SERVICE Switch at the power Center.
REMOTE CONTROL
A four-function Remote Control Switchplate is
provided in a convenient location for your daily
spa use.
It operates your spa, heater and two auxiliary
pieces of equipment.
SPA Switch :
Rotates motorized valves between pool circulation
and spa circulation. In "SPA" position, the filter
pump will automatically be activated, even if the
FILTER TIME Dial is not programmed on.
NOTE : If your pool is equipped with a pool
cleaner pump, a built-in safety circuit will
automatically turn off the pool cleaner
whenever the spa is in use.
HEAT Switch :
IF YOUR SYSTEM INCORPORATES A DUAL THERMOSTAT HEATER :
SPA Position :
Enables heater to heat the water to the "high" thermostat
setting whenever the filter pump is running;
OFF Position :
Disables the heater;
POOL Position : Enables heater to heat the water to the "low" thermostat setting
whenever the filter pump is running.
IF YOUR SYSTEM INCORPORATES A SINGLE THERMOSTAT HEATER :
SPA Position :
Enables the heater whenever the filter pump is running;
OFF Position :
Disables the heater;
POOL Position : Disables the heater.
AUX1 and AUX2 Switches :
These switches are used to control additional equipment (such as pumps, lights,
fountain, waterfall, etc.).
6
When operating or servicing this electrical equipment, basic safety
precautions should always be observed.
WARNING
To reduce the risk of injury, do not permit children to use this product unless they
are closely supervised at all times.
INTRODUCTION
The CP-30 is a remote control system which is designed to coordinate and
operate all of the equipment associated with your swimming pool and spa.
The system is comprised of three principal components:
1. The LX-30 Power Center;
2. Two CVA-24 Valve Actuators; and
3. The CP-30 Remote Control.
The Power Center automatically control the timing of your filter pump and pool
cleaner (if applicable); the Valve Actuators automatically switches the filter
between pool and spa circulation; and the Remote Control provides convenient
switching of your spa, heater, and two auxiliary pieces of equipment (such as: air
jets, lights, waterfall, etc.).
Additionally, the CP-30 incorporates important safety features which protect your
pool equipment from accidental damage.
Before using this equipment, obtain a copy of the Installation Instructions and
the completed EQUIPMENT CHECKLIST from your Pool Builder or Start-up
Person.
3
Advertisement
