Download Print this page

Pentair CP-30 User Manual page 4

Pool-spa switching system

Advertisement

POWER CENTER
FILTER TIMER Dial :
Check with your Pool Builder or Service company as to the amount of time
required to provide efficient filtration and cleaning of your pool.
To set the correct time of day, rotate the FILTER TIMER Dial in a clockwise
direction until the hours and minutes line up with the white arrow at eight o'clock
position on the clock face.
Pay particular attention to the AM and PM sections of the Dial.
To program the daily filtration cycle(s), depress the desired number of sections
around the perimeter of the Dial by pushing towards the center. For each section,
depress the filter pump will operate for 15 minutes.
FILTER PUMP Service Switch :
For normal system operation, keep this Switch in the "TIMER" position. The
"OFF" and "ON" positions allow your Pool Service-person to override the FILTER
TIMER Dial without altering the program.
PUMP OFF DELAY Light :
A built-in electronic delay circuit will automatically run the filter pump for an
additional 4 minutes whenever the system is turned off.
This feature enables the heater to cool down so that the heat exchanger and
plumbing are not damaged from overheating.
The PUMP OFF DELAY Light indicates that the delay is in effect.
NOTE : It is possible to temporarily cancel this delay by switching the FILTER
PUMP Service Switch to "OFF" and the back to "TIMER".
POWER ON Light :
Indicates that power has been connected to the system.
If this light is not on, consult your Pool Service-person.
SPA SERVICE Switch :
For normal system operation, keep this Switch in the "AUTO" position. The "FILL"
and "DRAIN" positions are used when cleaning the spa.
CLEANER TIMER Dial :
If your system incorporates a mechanical time clock for the pool cleaner, follow
the same procedure as the FILTER TIMER for setting the correct time of day and
programming the operating cycle(s) of your cleaner.
NOTE : A built-in protection circuit automatically activates the filer to pump
whenever the cleaner is running, even if the FILTER TIMER is not
programmed on. This safeguards against possible damage to the pool
cleaner pump when there is not water circulation.
4
5

Advertisement

loading