Troubleshooting - Electrolux ELM5400 Instruction Book

Troubleshooting

Problems
EN
The machine does not turn on.
The pump is very noisy. Both indica-
tor lights for small and big cups are
No water
The loading lever doesn't reach the
brewing position.
drips only from the spout and there
is also a spillage from the back of the
brewing spout.
The milk does not froth.
The frothed milk is too hot or cold.
12
Causes
The machine is not connected to the
power source.
No water in the tank.
Capsule inserted incorrectly.
Capsule already used.
Circuit is not primed
Not suitable milk.
The milk is too hot.
The whisking spiral is not in place.
ing to the Cappuccino and Latte line.
Solutions
Connect the machine to the power source.
Contact Electrolux customer service.
Fill the tank with fresh drinking water.
1. Prime the water circuit.
2. Check correct water tank position.
Empty the used capsule compartment.
Repeat the sequence, open and close the lever. If that
is not enough remove the capsule manually from the
compartment after unplugging the machine.
Preheat the cup with the hot water.
Open the lever and insert a new capsule.
Prime the water circuit.
Use fresh, partially skimmed milk.
Use milk at refrigerator temperature.
Make sure that the whisking spiral is correctly as-
sembled.
- Decrease or increase the milk amount.