Table of Contents
Advertisement
Step 1: Check Contents of the box
The box should contain the following items:
a) 1 x EMU™ Display unit
b) 4 x AA Batteries
Step 2: Register your EMU™
In order for your EMU™ to connect to the smart meter, you will need to register
your EMU™ with your utility. Please follow the procedure provided by your utility.
You will need the following information, which is found on the Information Label
on the back of your EMU™:
Address
Note that it may take some time for your utility to enable the smart meter to
connect with your EMU™. You should be advised by your utility how long this
will take. You must wait until this process is complete before proceeding; your
EMU™ will not function correctly until the smart meter is enabled.
Step 3: Assemble your EMU™
a. Open the battery cover on the back of your EMU™
by pushing down on the catch at top of the door.
b. Insert 4 AA batteries exactly as shown on inside of
the battery compartment. Note that putting a battery
in backwards can be hazardous, and may cause
extensive damage to your EMU™.
alkaline batteries; never mix battery types. Replace
all batteries at the same time.
c. Replace the battery cover by inserting the bottom
tabs first, then snapping the catch closed.
Quick Setup
MAC: 0015 8d00 001a ab91
IN: 6E5D 0732 8E2A 6FB4
MAC
This device complies with part 15 of the FCC Rules. Operation is
Subject to the following two conditions: (1) This device may not cause
Harmful interference, and (2) this device must accept any interference
Received, including interference that may cause undesired operation.
MODEL: RFA – Z105
FCC ID: YCXRFA – Z105
IC: 8919A – RFAZ105
www.rainforestautomation.com
N27879
©
2011 RAINFOREST AUTOMATION, INC.
Always use
EMU™
User Manual
Install
Code
5
Advertisement
Table of Contents
