Quick Setup - rainforest EMU-2 User Manual

Step 1: Check Contents of the box
The box should contain the following items:
a) 1 x EMU-2™ Display unit
b) 2 x AAA Batteries
c) 1 x AC Power Adapter
Step 2: Register your EMU-2™
Your EMU-2™ must be registered with your utility to connect to the smart meter.
It may come to you preregistered. If so, you can skip to the next step. If not, you
will need to contact your utility to register your device.
following information, which is found on the Information Label on the back of your
EMU-2™:
MAC
Address
Install Code
Note that it may take some time for your utility to enable the smart meter to
connect with your device. You must wait until this process is complete before
proceeding; your EMU-2™ will not function correctly until the smart meter is
enabled.
Step 3: Power up your EMU-2™
a. Plug the AC Adapter into a convenient power outlet.
b. Plug the AC Adapter cord into your EMU-2™.
c. Optionally, you can install the batteries by:
1) Pushing down on the catch and removing the battery
door at the back of the unit
2) Inserting 2 AAA batteries exactly as shown on inside
of the battery compartment. Note that putting a battery in backwards can be
hazardous, and may cause extensive damage to your EMU-2™. Always
use alkaline batteries; never mix battery types. Replace all batteries at the
same time.

Quick Setup

www.rainforestautomation.com
EMU-2™
User Manual
You will need the
5