Mark Levinson N 320S Owner's Manual page 44

Nº 320S
enter
Command
VOLUME UP Performs volume + button commands.
VOLUME DOWN Performs volume – button commands.
SELECT NEXT Performs select + button commands.
SELECT PREV Performs select – button commands.
INTENSITY KEY Performs display button commands.
MUTE KEY Performs mute button commands.
MONO KEY Performs mono button commands.
POLARITY KEY Performs polarity button commands.
STANDBY KEY Performs standby button commands.
ENTER KEY Performs enter button commands.
SETUP KEY Performs setup button commands.
BALANCE KEY Performs balance button commands.
The Nº 320S sends infrared signals at 40kHz, the most
common carrier frequency used in learning remote controls.
However, if the learning remote control seems unable to
learn IR commands:
• Eliminate obstructions between the learning remote
control and the left side of the front panel display.
• Adjust the distance between the learning remote control
and the left side of the front panel display.
• Make sure the learning remote control and the left
side of the front panel display are not exposed to
strong sunlight, halogen light, or fluorescent light.
This can cause IR reception to become unreliable.
• Replace the learning remote control batteries.
• If problems persist, contact an authorized Mark
Levinson dealer.
The table below indicates all available IR commands. For
toggle commands, the Nº 320S provides one IR command
for the toggle command as well as separate IR commands
for the positive and negative forms of the toggle command.
For instance, the MUTE KEY IR command teaches the
learning remote control to perform mute button commands,
while the GO MUTE IR command teaches the learning
remote control to activate mute and the GO UNMUTE IR
command teaches the learning remote control to deactivate
mute.
Description Command
EXIT STANDBY Takes the Nº 320S out of standby.
GO STANDBY Places the Nº 320S into standby.
GO INPUT 1-7 Selects the input assigned for the
corresponding stereo input connector
(1-7).
GO MUTE Activates mute.
GO UNMUTE Deactivates mute.
GO BALANCE Opens the balance control.
EXIT BALANCE Closes the balance control
DISPLAY OFF Sets display intensity to 0%.
DISPLAY DIM Sets display intensity to 25%.
DISPLAY HALF Sets display intensity to 50%.
DISPLAY FULL Sets display intensity to 100%.
Setup Menu
Description
(continued)
3-9