Specifications; Installation; Operation - CountyLine CLBU10C Owner's Manual

Installation • Operation
Description
This pump is designed for general purpose clear water
pumping needs. Delivers plenty of water at various
pressures. It can draw water from ponds, cisterns or
drilled wells.

Specifications

Power supply required. . . . . . . . . . . . . . . . . . . . . . . .115V, 60 HZ.
Liquid Temp. Range. . . . . . . . . . . . . . . . .Less Than 120°F (48.9°C)
Horsepower. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1/2
Maximum Capacity . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1420 GPH
Suction, Discharge Thread. . . . . . . . . . . . . . . . . . . . . . . 3/4" FNPT
Performance
Distance Performance (in GPM) at Discharge Pressure (PSI) Shown
to pump
above
5 10
water
0 ft. 1420 1320
5 ft. 1350 1240
10 ft. 1280 1170
15 ft. 1210 1100
20 ft. 1130 1030
25 ft. 1060 960
Location Of Unit
Locate pump as near as possible (vertically) to water
source, to keep suction lift (distance form water to pump)
as low as possible. Place pump on level support. Protect
against excess moisture and flooding.
Piping
Both suction and discharge ports are tapped for 3/4"
pipe. If using hoses, use hose to pipe thread adapter. To
prevent suction line collapse, use pipe or reinforced hose
only for suction line. Install strainer or puddle gulper on
end of suction line. Inspect and clean strainer frequently
(Figure 1). Plastic pipe can be used for all installations.
Electrical
Risk of electric shock. Can shock, burn or
kill. Unplug pump before servicing it. Do not handle
pump or attempt to work on pump with wet hands or
while standing on wet or damp floor.
Plug pump into 115 Volt, 60 Cycle outlet only. Pump is
equipped with 3-wire, grounded, cord and plug. Do not
modify or remove plug. Plug in to properly grounded,
grounding type outlet only. Make sure pump circuit
meets National Electrical Code. To avoid dangerous
electrical shock hazard, keep cord dry at all times.
20 30 40 Max PSI
1100 850 550
1050 800 480
980 740 430
920 570 360
860 500 300
780 430 240
NOTICE Pump motor is equipped with carbon brushes
with a normal operating life of about 300 hours. One
extra set of brushes is included. Replacement brushes are
available from your dealer. Motor brushes not included
in warranty.
Risk of fire. Incorrectly mounted brushes
may cause fire. Be sure curve on end of brush matches
curve on commutator.

Operation

NOTICE Do not run pump dry. Running pump without
water can damage impeller and may damage seal,
causing leaking or flooding, and will void warranty.
Discharge hose or
plastic pipe
55
Figure 1: Install the adapters and connect the inlet and
discharge hoses.
Figure 2: Remove the priming plug and fill the pump
body with water. The pump must be full of water
before you start it!
3/4" NPT to
Hose Adapter
O U
T
I N
Reinforced Inlet Hose
or Plastic Pipe
O U
T
I N
4
5608 0407
5609 0407