Table of Contents
Advertisement
PDF created with pdfFactory trial version
User Manual version 2503
3.1.4. Panel PC Module Assembly
The panel PC's individual modules are now ready to be
integrated to a complete panel PC module. Refer to Fig. 3-8.
1. Install the two speakers (B) to the chassis (C) with two
TMS MS*5 screws for each.
2. Attach the metal support bracket (G) to the chassis with
one TMS M3*4 screw with washer.
3. Integrate the CD-ROM module (D) to the chassis with two
TMS M3*4 screws.
bezel, for easy access, the CD-ROM is integrated with the
media reader module instead.
4. Retain the chassis to the front bezel module (A) with five
PMS M3*6 screws.
5. Connect the other ends of the two 2-pin speaker wires to
CN4
on the motherboard. The wire for the left speaker is
plugged to pin# 13, 15 and the wire for the right speaker
to pin# 14, 16 on CN4.
6. Connect the other end of the 40-pin IDE ribbon cable to
the CD-ROM board. Plug the other end of the CD-Audio
wire to the 4-pin black pin connector on the CD-ROM
board.
7. Plug I/O module (F) to the
motherboard. Retain the I/O module to chassis with five
FMS M3*5 screws. If no CD-ROM is accommodated with
the system, only four screws are needed to retain the I/O
module to the chassis.
3-32
www.pdffactory.com
If the LIBRA unit is with media reader
IOINF 1
slot on the
LIBRA 120 III (PC620 Intel 815E)
Advertisement
Table of Contents
