Table of Contents
Advertisement
PDF created with pdfFactory trial version
User Manual version 2503
3.1.3.2. Installing the SDRAM Memory Module
The panel PC's control board provides 2 x 168-pin DIMM
socket, able to support SDRAM memory from 32MB up to
512MB. To install the memory module, follow the
instructions below.
1.
Find the 168 pin DIMM socket on the motherboard
2.
There are two white eject levers at each end of the DIMM
socket. Push them outward until they separate from the
two vertical posts.
3.
Holding the memory module with the notch on the upper
right corner, then insert the memory module into the
DIMM socket at 90 angle.
4.
Push the two eject levers toward the vertical posts until
they click into place. The memory module is now
upright.
5.
Retain the memory module to the SDRAM socket by
firmly fastening the SDRAM and the eject levers together
with nylon cable ties.
The system is able to auto detect the new memory size and
there is no need to change the system configuration after
installation.
Make sure that the memory module you are using can handle
the specified SDRAM MHz. Inadequate memory module will
make the computer unable to boot up.
P
LEASE NOTE THAT ALTHOUGH THE MOTHERBOARD HAS TWO
DIMM
,
SOCKETS
YET DUE TO CHIPSET LIMITATION
MEMORY CAPACITY SUPPORTED IS
,
MODULES ARE INSERTED
3-26
www.pdffactory.com
,
512MB.
IF TWO
512MB
ONLY
SIZE CAN BE DETECTED
LIBRA 120 III (PC620 Intel 815E)
168-
PIN
THE MAXIMUM
512MB SDRAM
.
Advertisement
Table of Contents
