Table of Contents
Advertisement
PDF created with pdfFactory trial version
User Manual version 2503
(B)
(D)
(C)
F
3-2: LCD M
IGURE
After finishing the LCD module assembly, the module is to be
integrated to the touchscreen module to make a complete
display module.
6.
Use special air blower to blow any dust between the LCD
and touchscreen before the two modules are assembled
together.
7.
Retain the LCD module (Fig. 3-4, B) and the touchcreen
module (Fig. 3-4, A) together with four PMS M3*8
screws. Make sure the touchscreen flat cable is coming
through the opening at the LCD holder (Figure 3-2, C)
for later connection to the touchscreen controller.
If you reverse the complete display module at this time, you
will see three cables, LCD cable, invertor cable and
touchscreen flat cable come out from the rear-side opening
(D) of the LCD holder.
3-24
www.pdffactory.com
(A)
A
ODULE
SSEMBLY
LIBRA 120 III (PC620 Intel 815E)
(
)
front
(
)
back
Advertisement
Table of Contents
