Cuckoo CRP-M10 Fuzzy Series Operating Instructions Manual page 12

HOW TO CLEAN
How to clean the soft steam cap
Do not touch the surface of the soft steam cap right after cooking. You can get burned.
Take out soft steam cap
as in the figure.
When assembling the soft
steam cap, match the sill
of the below and insert the
cap firmly by pressing it in
the direction of the arrow.
How to use handle
1. Handle must be turned to "Lock" during Cooking.
When the lamp is turned on it means that it is ready to cook.
2. After cooking, turn the handle from "Lock" to "Unlock" turn
the handle to open.
If there is unreleased steam in the Inner pot it might be hard to
turn the handle. In this case twist the pressure weight and let the
excess steam out. Do not open by force.
3. Handle must be turned to "Unlock" when opening and closing.
When top cover does not close perfectly
Do not try to close the top cover by force. It can cause problems.
1. Check to make sure the inner
pot is place correctly inside the
main body.
2. To close the top cover turn the
handle to unlock, in shown in the
picture on the right.
Disassemble soft steam cap
in the rear by pressing the
hook in direction, at the arrow
and wash it frequently with an
neutral detergent and sponge.
When installing the soft
steam cap, insert the cap
firmly by pressing in the
direction of the arrow
indicated in the figure.
Disassemble the rubber
packing in the direction of
the arrow.
How to use with the packing
Correct
Carefully insert the packing the correct way.
If the lamp does not turn on, it would
not operate the "Cook" and "Preset"
buttons. Make sure the handle is
located in "Lock".
3. If there is excess steam inside the
inner pot it might be difficult to lock the
handle. Twist the pressure weight and
allow the excess steam to release.
Then try to turn the handle again.
When fitting the rubber
packing into the plate,
please make sure the
packing is facing the
correct direction.
Wrong