Table of Contents
Advertisement
TAPE TO Select Switch
24
Pushing this switch to left will route the signal from TAPE IN to
CH9~10 path, and the signal will be affected by channel level
control and main level control, while to right will route the signal
to main mix bus, the signal will be affected only by main level
control.
2-TRACK IN
25
Your
APM80.1500
and right). If you wish to listen to your mix from a tape recorder,
DAT or cassette, please use these tape input jacks. Depending
on the setting of TAPE TO select switch, you can assign the signal
coming from the tape recorder (DAT or cassette) to CH9~10 path
or main mix bus.
2-TRACK OUT
26
Your
APM80.1500
and right). Via these jacks, you can route the main mix signal into
a tape recorder or DAT for recording.
4.4 DSP Section
APM80.1500 features the special 256 position multi-effect,
further details please refer to following content.
PRESETS Control
27
Adjust this knob to select the right effect you wish to perform.
There are total 16 options for you: several kinds of reverb, mono
and stereo delay, modulation effects, and versatile two-effect
combination.
VARIATIONS Control
28
Since you have selected the preferable effect, the next step, please
go with the fine consideration, there are also total 16 variations for
each preset, and each variation has been designed modifying several
parameters.
DSP MUTE Switch
29
This switch is used to activate/deactivate the effect facility. Sometimes,
you can also use the following FOOT SW jack for convenient operation
CLIP/MUTE LED
30
This LED lights up when the input signal is too strong. In case of
the digital effect module being muted, this LED also lights up.
DSP TO MON Control
31
This control is used to control the volume of
monitor mix, which can be varied from -
features dual RCA jacks for 2-track in (left
features dual RCA jacks for 2-track out (left
to +10dB.
effect
signal sent to
12
25
26
DSP
PRESETS
1
16
2
15
3
4
14
5
13
6
12
7
11
8
10
9
CLIP
DSP
29
MUTE
MUTE
VARIATIONS
1
16
2
15
3
4
14
13
5
6
12
7
11
8
10
9
DSP
TO MON
-
+10dB
PRESETS:
1. VOCAL 1
2. VOCAL 2
3. LARGE HALL
4. SMALL HALL
5. LARGE ROOM
6. SMALL ROOM
7. PLATE
8. TAPE REVERB
9. SPRING REVERB
10. MONO DELAY
11. STEREO DELAY
12. FLANGER
13. CHORUS
14. REVERB + DELAY
15.
REVERB +
FLANGER
16. REVERB + CHORUS
0
dB
DSP
TO MAIN
-
+10dB
FOOT
SW.
24
27
30
28
31
32
33
Advertisement
Table of Contents
