Led Indicators (Crd5501-4001Er); Ethernet Settings; Configuring Ethernet Proxy Settings - Motorola MC67 Integrator Manual

LED Indicators (CRD5501-4001ER)

There are two green LEDs on the front of the cradle and two green LED on the Primary port on the back of the cradle.
These green LEDs light and blink to indicate the data transfer rate. When the LEDs are not lit the transfer rate is 10
Mbps.
Table 4: CRD5501-4001ER LED Indicators
Data Rate
1 Gbps
100 Mbps
10 Mbps

Ethernet Settings

The following settings can be configured when using Ethernet communication:
• Proxy Settings
• Static IP.

Configuring Ethernet Proxy Settings

The MC67 includes Ethernet cradle drivers. After inserting the MC67, configure the Ethernet connection:
Procedure:
1
Touch .
2
Touch .
3 Touch Ethernet.
4 Slide the switch to the ON position.
5 Place the MC67 into the Ethernet cradle slot.
6 Touch and hold Eth0 until the menu appears.
7 Touch Modify Proxy.
Figure 19: Ethernet Proxy Settings
8 Touch the Proxy settings drop-down list and select Manual.
9 In the Proxy hostname field, enter the proxy server address.
10 In the Proxy port field, enter the proxy server port number.
Left 1000 LED (Green)
On/Blink
Off
Off
Accessories | 33
Right 100 LED (Green)
Off
On/Blink
Off
MN000116A02-A | May 2015