Setup
Changing Blades
There is a large variety of cutting and scraper blades avail-
able for the Vecturo (see
12 for blade choices). Blades should be changed for dif-
ferent tasks or when they become dull. The Fast Fix system
allows blades to be changed without tools.
CAUTION! Take care when changing blades and
consider wearing gloves when handling the blades.
Unplug the tool to prevent accidental startup.
►
The cutting blade can become very hot during use,
►
and can cause burns.
The cutting edges are sharp and pose a significant
►
risk for injury.
1. Unplug the Vecturo from power.
2. Raise the Fast Fix lever and rotate it a full 180° to release
the blade mandrel. (The lever is compressing very strong
springs and requires a fair amount of force to fully rotate
it.)
Supplemental Owner's Manual
"Cutting Blade
Selection" on page
Fast Fix
Lever
180°
3. Lift the blade and mandrel out of the arbor.
Mandrel
Arbor
4. Inert the mandrel through the new blade.
5. The blade may be positioned at any angle in 30 degree
increments. Rotate the blade to the desired position and
insert the blade and mandrel into the arbor.
6. While making sure the mandrel is fully seated in the
arbor, close the Fast Fix lever.
7. Check to make sure the blade is firmly held and cannot
be wiggled.
Blade
Fast Fix
Lever
360/30°
7