Setting The Network [Network]; Network Connecting; Network Connecting (Dhcp=Off) - Marantz M-CR603 User Manual

ENGLISH
Symbols used to indicate buttons in this guide
Button located on both the main unit and the remote control
Button only on the main unit
Button only on the remote control
<ENTER> u/i p
[MENU]
u
i
30

Setting the network [Network]

When using this unit with the broadband router's DHCP function
BUTTON
enabled, this unit automatically performs the IP address setting and
<BUTTON>
other settings.
[BUTTON]
When using this unit connected to a network with no DHCP function,
make the settings for the IP address, etc., at "Network connecting
(DHCP=Off)" (vpage 30).
NOTE
When setting manually, check the setting contents with the network
administrator.

Network connecting

Connect the LAN cable.
1
(vpage 8 "Connecting to a home network (LAN)")
Turn on this unit.
2
(vpage 11 "Turning the power on")
Press
[MENU]
3
Turns on the Menu settings mode and the Menu appears on
the display. (vpage 26 "Menu map")
Use ui
4
(Off)", then press
"DHCP" menu appears.
• When the network connection is set to "DHCP (On)", go to step 6.
ui
5 Use
<ENTER>
"Connecting" menu appears.
ui
Use
6
[ENTER/MEMO]
MEMO] ,
p
The connection starts.
• When the connection is made successfully, "Succeeded" appears.
If the connection fails, "Failed" appears.
[NUMBER]
NOTE
You may need to set the network connection manually, depending on
the provider you use. To set the connection manually, use the setting
procedure of "Network connecting 'DHCP=Off)".
.
to select "Network"-"Connecting"-"DHCP
[ENTER/MEMO] , <ENTER> or
to select "On", then press
[ENTER/MEMO]
or p .
to select "Connection", then press
[ENTER/
p
<ENTER> or .

Network connecting (DHCP=Off)

Perform steps 1 to 4 of the "Network connecting"
1
procedure and select "Off" in step 5.
"Connecting" menu appears.
Use ui to select "IP Address", then press
2
p
, or .
MEMO] <ENTER>
"IP Address" input menu appears.
uip
3 Use or
[NUMBER] (0 – 9)
and press
[ENTER/MEMO]
uip
4 Use or [NUMBER] (0 – 9)
address for Subnet Mask, Gateway, Primary DNS,
and Secondary DNS.
After you input all required addresses, perform
5
step 6 of "Network connecting" to connect to the
Internet.
p
.
,
[ENTER/
to input the address
or .
<ENTER>
to input the